This guide summarises how an Econovex deep panoramic fire is built into a media wall or chimney breast, based on the manufacturer's manual. Always read the full manual supplied with your fire before you start, and use a qualified electrician for any electrical work.
Before you start
- Test the fire first. Plug it in and check it works, and pair the remote, before you build it in.
- Choose a non-load-bearing wall. The manual says the fire must only be recessed into non-load-bearing walls.
- Avoid damp locations and keep the fire at least 1 m from curtains, furniture and other combustible materials.
- Tools: Phillips screwdriver, stud finder, level, tape measure, electric drill and wood drill bit.
1. Plan the opening
Build the framed opening to the recess size for your model:
| Model | Recess opening (W x H x D) | Overall size (W x H x D) | Pairs with |
|---|---|---|---|
| Econovex 1270 | 1270 x 560 x 300 mm | 1296 x 570 x 311 mm | 50" to 55" TV |
| Econovex 1600 | 1600 x 560 x 300 mm | 1626 x 570 x 311 mm | 55" to 65" TV |
| Econovex 1800 | 1800 x 560 x 300 mm | 1826 x 570 x 311 mm | 65" to 75" TV |
| Econovex 2000 | 2032 x 560 x 300 mm | 2058 x 570 x 311 mm | 65" to 85" TV |
Keep to the minimum clearances:
- Floor: at least 150 mm from the bottom of the fire to the floor.
- Above: at least 200 mm from the top of the fire to a TV, mantel or ceiling.
- Sides and back: 0 mm.
- In front: keep furniture, curtains and other combustible materials at least 1 m away.
2. Plan the power
The fire is a 230V plug-in unit with a 2 m cord and a 3-pin plug. The manual recommends a dedicated circuit, with the socket at the top right of the framed opening, and advises against plugging other appliances into the same circuit. Have a qualified electrician install the socket.
3. Frame and line the opening
Frame the opening and finish the inside walls of the enclosure (for example with plasterboard), so no insulation or vapour barrier can touch the fire.
4. Fit the fire
Fit the four supplied L-brackets, then secure the fire in the opening with drywall screws at least 1¼ inch (32 mm) long.
5. Choose 3-sided, corner or flush
For a 3-sided (bay) fit, leave both ends open. For a 2-sided (corner) fit, fit a side cover on the end you want to hide. For a flush fit, fit both side covers. The side glass must be installed before the metal side cover goes on.
6. Finish the wall
Mask and cover the fire, then plaster or board up to the finishing edges around the firebox. When it is done, only the glass and the slim heat vent along the top should show.
7. Dress the fire and fit the glass
Spread the ember media evenly across the bed and place the log set. Fit the front glass into the bottom channel at an angle, stand it upright and secure the top retainer bracket. Fit each side glass into its top channel, swing the bottom into the firebox, slide it down into the bottom channel and push it back until it stops.
Looking after it
Always switch off and unplug before cleaning. Clean the glass with glass cleaner sprayed onto a cloth (never directly onto the fire), and vacuum or dust the vents. Never spray the fire with water, and do not open any panels: there are no user-serviceable parts inside.
Questions about fitting a fire from our panoramic fires range? Get in touch.
